![]() ![]() Occasionally I have been testing functionality direct to the internet, when I switch to the pppoe0 connection to my ISP (hardening some of the rules as I do). The reason I have both eth1 and pppoe0 as my WAN interface in the config is that I’m prototyping it on my existing network. But regardless, shouldn’t I still be able to ping or do some other kind of test to get data over that interface, regardless of routing? I’m new to zone-policy and PBR though, so I’m not sure if it’s meant to. Regardless of routing, should I still just be able to ping over that interface (ping -I wg1 1.1.1.1) and get a response?Īs you can see in my configuration below, I’m trying to route a specific network group via the VPN, but the route doesn’t appear in the routing table. ![]() Hi all, I’m trying to set up a connection to Mullvad using 1.4-rolling-202111200317, and the connection is up and handshaking, but I can’t send any data over it. ![]()
0 Comments
Leave a Reply. |